Reinforcement for flat trunking for reinforcing flat trunking Universal size b=70mm, a=49mm, L=910mm for flat trunking from b=140mm.

Material: Elastomeric soft foam (FEF)Cell structure: closedColour: Black / AnthraciteMax. temperature: +85°C Min. temperature: -50°C Thermal conductivity: 0.034 to 0.037Water vapour resistance: ≥10,000 µFire classification: B-s3, d0Reaction to fire: Self-extinguishing, no droplets, no flame spreadHealth aspects: No bacterial or fungal growthSelf-adhesive insulation mats are typically used for thermal insulation in various applications. Their primary purpose is to reduce heat loss or to prevent heat transfer.Here are some typical areas of application and installation instructions: Applications:1. Building insulation: Self-adhesive insulation mats can be applied to walls, ceilings and floors to reduce heat transfer between the interior and exterior of a building. They help lower energy consumption and improve thermal comfort. 2. Pipe insulation: These insulation mats can be wrapped around pipes to minimise heat loss and prevent pipes from freezing in cold environments. This is especially important in heating and plumbing systems.3. Vehicle insulation: In vehicles, self-adhesive insulation mats can be used to protect the interior from heat and cold. They contribute to improved driving comfort and can also help reduce external noise. 4. Industrial applications: In industrial plants these insulation mats are often used to protect equipment and systems from extreme temperatures and to increase energy efficiency.Installation:1. Preparation: Ensure that the surface to which the insulation mat will be applied is clean, dry and free from dirt, grease or other contaminants. 2. Cutting: Cut the insulation mat to the required dimensions with a sharp knife or scissors. Make sure to allow enough material for overlaps or overhangs. 3. Application: Remove the protective film from the back of the insulation mat and press it firmly onto the surface to be insulated. Start in a corner and work evenly to avoid air bubbles and ensure good adhesion.4. Sealing: If required, the overlaps of the insulation mats can be sealed with special adhesive tapes to ensure better insulation.5. Finishing: Check the installed insulation mats for any gaps or irregularities and correct them if necessary. Ensure that all edges and joints are well sealed. With proper installation, self-adhesive insulation mats can effectively contribute to thermal insulation and reduce energy consumption in various applications.